Fixing my OnePlus 12 myself: back glass, charging port and battery

Heads up: some links in this article are affiliate links. If you buy through them I may earn a small commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. I only recommend gear I'd run myself.

TL;DR: Three things were wrong with my OnePlus 12 at once: a cracked back glass, a charging port that stopped charging, and a worn battery. I fixed all three myself in a few hours for about $60 in parts. On a difficulty scale I’d call it a 3 or 4 out of 10. The most fiddly part was getting the back glass off. The front screen stays on.

What was broken

All three at the same time, which is what pushed me into doing it myself instead of paying for one repair and living with the other two:

  • The back glass was cracked.
  • The charging port stopped charging.
  • The battery was worn out.

If your own phone stops charging, test the cable first: why half your USB cables are charge-only.

What I bought

Three parts and a set of opening tools. Nothing exotic.

Opening tools. A two-piece set: opening pliers with suction cups. The suction cups grip the glass so you can lift an edge and get a pick under it.

Replacement back glass, with the camera lens glass included. Get one with the lens cover in it, because the camera glass sits in the same panel.

Charging port board (USB-C port on its flex cable), made for the OnePlus 12.

A replacement battery, the BLPA25 that the OnePlus 12 takes. Mine came with its own small tool kit.

How it went

It took a few hours start to finish. Most of it is patient, careful work rather than anything difficult: take things apart in order, keep track of which screw came from where, and don’t force anything.

The hard part was getting the back glass off. The front screen stays on the whole time. That’s where most of the time and most of the nerves went.

Label the old battery and the other parts as they come out, so old and new pieces never get mixed up.

If you’re thinking about doing this

Some general advice for any glued-together phone, not specific to my repair:

  • Heat softens the adhesive. A hair dryer or heat pad on the panel you’re lifting makes the pick slide in instead of fighting you.
  • Disconnect the battery first before you touch any other connector.
  • Treat the battery with respect. It’s lithium. Keep any heat moderate and away from the cell, and avoid sharp metal tools near it. Never puncture or bend it, stop if it swells or smells, and take the old one to a proper recycling point rather than the bin.
  • Work over a tray and keep screws in the order they came out.
  • Water resistance is gone after you open a phone unless you reseal it properly with new adhesive. Treat a home-repaired phone as not waterproof.

Was it worth it?

All the parts and tools together came to about $60. A repair shop would have charged for those same parts and then labour on top, for three separate jobs. This was a last-ditch attempt, too: if it hadn’t worked, I’d have had to replace the phone. A few hours instead of that was well worth it.